11. Controlling NeoPixels

NeoPixels, also known as WS2812 LEDs, are full-colour LEDs that are connected in serial, are individually addressable, and can have their red, green and blue components set between 0 and 255. They require precise timing to control them and there is a special neopixel module to do just this.

To create a NeoPixel object do the following:

>>> import machine, neopixel
>>> np = neopixel.NeoPixel(machine.Pin(4), 8)

This configures a NeoPixel strip on GPIO4 with 8 pixels. You can adjust the “4” (pin number) and the “8” (number of pixel) to suit your set up.

To set the colour of pixels use:

>>> np[0] = (255, 0, 0) # set to red, full brightness
>>> np[1] = (0, 128, 0) # set to green, half brightness
>>> np[2] = (0, 0, 64)  # set to blue, quarter brightness

For LEDs with more than 3 colours, such as RGBW pixels or RGBY pixels, the NeoPixel class takes a bpp parameter. To setup a NeoPixel object for an RGBW Pixel, do the following:

>>> import machine, neopixel
>>> np = neopixel.NeoPixel(machine.Pin(4), 8, bpp=4)

In a 4-bpp mode, remember to use 4-tuples instead of 3-tuples to set the colour. For example to set the first three pixels use:

>>> np[0] = (255, 0, 0, 128) # Orange in an RGBY Setup
>>> np[1] = (0, 255, 0, 128) # Yellow-green in an RGBY Setup
>>> np[2] = (0, 0, 255, 128) # Green-blue in an RGBY Setup

Then use the write() method to output the colours to the LEDs:

>>> np.write()

The following demo function makes a fancy show on the LEDs:

import time

def demo(np):
   n = np.n

   # cycle
   for i in range(4 * n):
      for j in range(n):
         np[j] = (0, 0, 0)
      np[i % n] = (255, 255, 255)
      np.write()
      time.sleep_ms(25)

   # bounce
   for i in range(4 * n):
      for j in range(n):
         np[j] = (0, 0, 128)
      if (i // n) % 2 == 0:
         np[i % n] = (0, 0, 0)
      else:
         np[n - 1 - (i % n)] = (0, 0, 0)
      np.write()
      time.sleep_ms(60)

   # fade in/out
   for i in range(0, 4 * 256, 8):
      for j in range(n):
         if (i // 256) % 2 == 0:
            val = i & 0xff
         else:
            val = 255 - (i & 0xff)
         np[j] = (val, 0, 0)
      np.write()

   # clear
   for i in range(n):
      np[i] = (0, 0, 0)
   np.write()

Execute it using:

>>> demo(np)